Kia Sedona: Side Impact Sensor (SIS) Description and Operation
Side Impact Sensor (SIS) system consists of two Pressure Side
Impact Sensors (P-SIS), installed at each center of front door modules
(LH and RH), two SIS, installed at each center of nearby pillars (LH and
RH), and two rear SIS, installed in the rear pillars (LH and RH).
Pressure Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM determines the deployment of airbag and the time of
deployment based on the collision signal from the SIS at the time of
collision.
Removal
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front i ...
Other Information:
Canister Close Valve (CCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV terminal 1 and 2.
4.
Check that the resistance is within the specific ...
Muffler Repair procedures
Removal and Installation
Front Muffler
1.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.
Disconnect the RH rear oxygen sensor (HO ...