Kia Sedona: Rear Wheel Guard Repair procedures - Body Side Moulding - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Wheel Guard Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Body Side Moulding / Rear Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
Remove the rear mud guard.
(Refer to Body Side Moulding - "Rear Mud Guard")
3.
After loosening the mounting clips and screws, remove the front wheel guard (A).

4.
Install in the reverse order of removal.
   
Replace any damaged clips.
Front Wheel Guard Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Front Mud Guard Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position. 2. Close the sunshade and sunroof complet ...

Transmitter Repair procedures
Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn''t flicker ...

Categories

Copyright © www.kisedona.com 2016-2026