Kia Sedona: Parking Brake Pedal Assembly Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Repair procedures

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel")

3.	Remove the junction box. (Refer to Body Electrical System - "Relay Box(Passenger Compartment"))

4.	Disconnect the parking brake switch connector.

5.	Remove the parking brake cable mounting nuts (A).

6.	Remove the parking brake pedal mounting bolts (A) and nut (B).

7.	Remove the parking brake cable the fixing clip(A, B), and then remove the parking brake pedal.

Installation

1.	Install the holding clip (A, B) after fixing the parking brake cable.

2.	Install the parking brake pedal, and then install the parking brake pedal mounting bolts (A) and nut (B).

Adjust the parking brake pedal stroke by turning the adjusting nut (A).

(1)	Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.

(2)

Adjust the adjusting nut (A) for parking brake pedal stroke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lb).

1)	The parking brake adjustment must be carried out after adjusting the rear shoe.

2)	After adjusting parking brake, notice following matter.

a.	Must be free from clearance between adjusting nut and pin.

b.	Check securely that the brake is not dragging.

4.	Reconnect the parking brake switch connector.

5.	Install the junction box. (Refer to Body Electrical System - "Relay Box(Passenger Compartment"))

6.	Install the crash pad lower panel. (Refer to Body - "Crash pad lower panel")

Adjustment

Parking Brake Pedal Stroke Adjustment

1.	Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.

Adjust the adjusting nut (A) for parking brake pedal stroke of 8-9 notches when operating effort is 294 N (30kgf, 66lbf).

1)	The parking brake adjustment must be carried out after adjusting the rear shoe.

2)	After adjusting parking brake, notice following matter.

a.	Must be free from clearance between adjusting nut and pin.

b.	Check securely that the brake is not dragging.

Parking Brake Assembly Repair procedures

Removal Parking Brake Shoe 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear tire and wheel. 3. Remove the rear brake caliper and Rear disc brake. (Refer ...

Parking Brake Cable Repair procedures

Removal Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") ...

Other Information:

Cowl Cross Bar Assembly Components and Components Location
Component Location 1. Cowl cross bar assembly ...

Description and Operation
Description Block Diagram LDWS is composed of below units NoItemFunctionPosition1LDWS UNIT 1) Lane Departure Warning System (LDWS) : Detects drive lane in front and engages warning function ...

Kia Sedona: Parking Brake Pedal Assembly Repair procedures

Parking Brake Assembly Repair procedures

Parking Brake Cable Repair procedures

Other Information:

Categories