Kia Sedona: Shift Cable Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Repair procedures

Removal

1.	Move the shift lever to "N" range.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner)

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

Loosen the nut (A) and then remove the shift cable (B) from the bracket (c).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.	Remove the knob (A) and boots (B) by pulling them in the direction of the arrow after separating the boots from the console upper cover.

6.	Remove the floor console assembly. (Refer to Body - "Console")

7.	Remove the shift cable (A) from the shift lever.

Remove the cable retainer (A) by loosening the nuts (B)

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

9.	Remove the shift cable by pulling it inward.

Installation

Install in the reverse order of removal.

•	Check that the shift lever and manual control lever are placed in the "N" position.

•	Insert the shift cable after checking the direction of projection (A) to prevent wrong assembly.

Shift Cable Components and Components Location

Components 1. Shift lever assembly2. Shift cable assembly3. Shift cable retainer ...

Hydraulic System

...

Other Information:

Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. Slow down when ...

Output Speed Sensor Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. M ...

Kia Sedona: Shift Cable Repair procedures

Shift Cable Components and Components Location

Hydraulic System

Other Information:

Categories