Inspection |
1. |
Check the tire pressure.
17(inch) : 241+7kPa (35 + 1.0 psi)
18(inch) : 241+7kPa (35 + 1.0 psi)
19(inch) : 241+7kPa (35 + 1.0 psi) |
1. |
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability. |
2. |
If the steering pulls to the opposite side, rotate the front and rear tires, and perform a road test again. |
3. |
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test. |
4. |
If the steering continues to pull to the opposite side, replace the front wheels with new ones. |
|
1. |
Measure the tread depth of the tires.
|
2. |
If the remaining tread depth (A) is less than the limit, replace the tire.
|
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]10.0 (0. ...