Kia Sedona: Power Window Motor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Power Windows / Power Window Motor Repair procedures

Inspection

•	Wrap a protective tape around tools used in disassembling such as screwdriver or remover.

•	Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.

•	Be careful not to scratch the door trim and other parts.

Front Power Window Motor

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Disconnect the motor connector from the motor.

4.	Connect the terminals No. 1 and No. 2 to battery boltage (12V) and check that the motor operates smoothly when connected to the following terminals: [Safety window motor]

5.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [Standard window motor]

Rear Power Window Motor

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

3.	Disconnect the motor connector from the motor.

4.	Connect the terminals No. 1 and No. 2 to battery boltage (12V) and check that the motor operates smoothly when connected to the following terminals: [Safety window motor]

5.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [Standard window motor]

Power Window Motor Schematic Diagrams

Circuit Diagram ...

Power Window Switch Components and Components Location

Components Driver Power Window Switch Connector Pin Information No.Connector ANo.Connector B1GND1Driver mirror horizontal_output2Mirror sensor GND_output2Driver mirror vertical_output3Driver un ...

Other Information:

Press brake pedal to start engine (for smart key system)
This warning message illuminates if the Engine Start/Stop Button changes to the ACC position twice by pressing the button repeatedly without depressing the brake pedal. It means that you ...

SS-A Solenoid Valve(ON/OFF) Specifications
Specification ItemSpecificationControl type ON/OFFCurrent value (mA)5.0 Coil resistance(Ω)10 ~ 11 ...

Kia Sedona: Power Window Motor Repair procedures

Power Window Motor Schematic Diagrams

Power Window Switch Components and Components Location

Other Information:

Categories