Kia Sedona: Output Speed Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Disconnect the solenoid valve connector (A).

Measure the resistance between power terminal (3) and signal terminal (4).

Specification : Approx. 0.88 MΩ

Removal

1.	Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")

2.	Disconnect the input & output speed sensor connector (A).

Remove the input & output speed sensor (B) after loosening the bolts.

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation

Install in the reverse order of removal.

•	Refill the automatic transaxle with fluid. (Refer to Hydraulic System - "Fluid")

•	• Confirm that there is no fluid leakage on connections after repairing.

Output Speed Sensor Schematic Diagrams

Circuit Diagram ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Specification Item SpecificationControl typeN/L (Normal Low)Control pressure kpa (kgf/cm², psi)"9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3 ...

Other Information:

Releasing the parking brake
To release the parking brake, depress the parking brake pedal a second time while applying the foot brake. The pedal will automatically extend to the fully released position. WARNING - Park ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Carefully observe the instructions described in this manual as mi ...

Kia Sedona: Output Speed Sensor Repair procedures

Output Speed Sensor Schematic Diagrams

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Other Information:

Categories