Kia Optima Manuals

Kia Sedona: Transaxle Oil Temperature Sensor Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Transaxle Oil Temperature Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between + terminal (9) and - terminal (13).

5.
Check that the resistance is within the specification.
Item
Specification
Temp.[(°C)°F] / Resistance (kΩ)
(-40)-40 / 48.1
(-20)-4.0 / 15.6
(0)32.0 / 5.88
(20)68.0 / 2.51
(40)104.0 / 1.19
(60)140.0 / 0.61
(80)176.0 / 0.32
(100)212.0 / 0.18
(120)248.0 / 0.10
(140)284.0 / 0.06
(150)302.0 / 0.05

Removal
   
The oil temperature sensor is integrated with the solenoid valve main connector and can not be disassembled. The oil temperature sensor should be replaced with the solenoid valve main connector.
1.
Move the shift lever to "N" range.
2.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
3.
Disconnect the input & output speed sensor connector (A).
4.
Loosen the solenoid valve harness bolts (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Disconnect the solenoid valve connector (A).

6.
Remove the clip (A) and then remove the connector by pressing it downward.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Confirm that there is no fluid leakage on connections after repairing.
Transaxle Oil Temperature Sensor Schematic Diagrams
Circuit Diagram ...

Input Speed Sensor Specifications
Specification ItemSpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output voltage (V)High: 1.18 ~ 1.68Low: 0.59 ~ 0.84 ...

Other Information:

Smart key unit Components and Components Location
Components (1) Connector Pin Information No.Connector AConnector BConnector C1Immobilizer antenna GND outputB+IGN12Bumper antenna GND output--3Rear antenna GND output--4Interior antenna 2 GND ou ...

Components and Components Location
Component Location 1. Front sunroof2. Front & Rear sunroof switch3. Front sunroof motor & controller4. Rear sunroof5. Rear sunroof switch6. Rear sunroof motor & Controller ...

Categories

Copyright © www.kisedona.com 2016-2026