Kia Sedona: Smart key unit Components and Components Location| Components (1) |

| No. | Connector A | Connector B | Connector C |
| 1 | Immobilizer antenna GND output | B+ | IGN1 |
| 2 | Bumper antenna GND output | - | - |
| 3 | Rear antenna GND output | - | - |
| 4 | Interior antenna 2 GND output | - | Passenger''s door switch |
| 5 | Driver''s door antenna GND output | GND power2 | SSB_switch1 inpuf |
| 6 | Interior antenna 1 GND output | B+POWER | COM EMS |
| 7 | Passenger''s door antenna GND output | - | RPM signal inpuf |
| 8 | SSB Illumination (OFF) output | - | Wheel speed input |
| 9 | SSB Illumination (ACC) output | - | Start Feedback signal inpuf |
| 10 | SSB Illumination (IGN) output | GND power1 | Brake switch signal input |
| | |||
| 11 | SSB Illumination (+) output | | P signal input (AT specification) |
| 12 | Exterior buzzer output | - | |
| 13 | Immobilizer antenna power output | - | |
| 14 | Bumper antenna power output | - | |
| 15 | Rear antenna power output | - | |
| 16 | Interior antenna 2 power output | SSB switch2 inpuf | |
| 17 | Driver''s door antenna power output | C CAN HIGH | |
| 18 | Interior antenna 1 power output | C CAN LOW | |
| 19 | Passenger''s door antenna power output | B CAN LOW | |
| 20 | IGN1 relay output | B CAN HIGH | |
| 21 | IGN2 relay output | Driver''s door switch input | |
| 22 | ACC relay output | - | |
| 23 | SSB Illumination (-) output | - | |
| 24 | Starter relay output | - | |
| 25 | | - | |
| 26 | ACC inpuf | ||
| 27 | IGN2 | ||
| 28 | - | ||
| 29 | - | ||
| 30 | - | ||
| 31 | - | ||
| 32 | - |
Smart key Repair procedures
Smart key unit Schematic DiagramsDefroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the wind ...
96,000 km (60,000 miles) or 48 months
❑ Rotate tire
❑ Inspect battery condition
❑ Inspect vacuum hose
❑ Inspect air conditioning refrigerant
❑ Inspect brake hoses and lines
❑ Inspect drive sh ...