Kia Optima Manuals

Kia Sedona: Intake Air Temperature Sensor (IATS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Intake Air Temperature Sensor (IATS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.
Temperature
Resistance (kΩ)
°C
°F
-40
-40
40.93 ~ 48.35
-20
-4
13.89 ~ 16.03
0
32
5.38 ~ 6.09
10
50
3.48 ~ 3.90
20
68
2.31 ~ 2.57
40
104
1.08 ~ 1.21
60
140
0.54 ~ 0.66
80
176
0.29 ~ 0.34

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the intake air temperature sensor connector (A).
3.
Remove the mounting bolt (B), and then lift up to remove the sensor from the air cleaner assembly.

Installation
   
•
Install the component to the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage sensor when installing.
1.
Install in the reverse order of removal.
Intake air temperature sensor mounting bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Intake Air Temperature Sensor (IATS) Schematic Diagrams
Circuit Diagram ...

Engine Coolant Temperature Sensor (ECTS) Specifications
Specification TemperatureResistance (kΩ)°C°F-40-4048.14-20-414.13 ~ 16.830325.7920682.31 ~ 2.59401041.15601400.59801760.32 ...

Other Information:

Driver Airbag (DAB) Module and Clock Spring Description and Operation
Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash oc ...

Alternator Specifications
Specification ItemSpecificationRated voltage13.5V , 150ASpeed in use1,500 ~ 18,000rpmVoltage regulatorIC Regulator built in typeDefault regulated voltage (V) [COM terminal]14.0 ~ 15.5 (-35°C)14. ...

Categories

Copyright © www.kisedona.com 2016-2026