Kia Sedona: Repair procedures
| Component Replacement After Deployment |
Before performing any SRS repairs, use the GDS to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing related
DTCs. |
When the front airbag(s) is/are deployed after a collision, replace the following items:
| – |
SRSCM |
| – |
Deployed airbag(s) |
| – |
Seat belt pretensioner(s) |
| – |
Front impact sensors |
| – |
SRS wiring harnesses |
| – |
Inpsect the clock spring for heat damage.
If any damage is found, replace the clock spring.
|
When the side/curtain airbag(s) is/are deployed after a collision, replace the following items:
| – |
SRSCM |
| – |
Deployed airbag(s) |
| – |
Side impact sensor(s) for the deployed side(s) |
| – |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm that the SRS airbag system is OK.
| – |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a lamp check.
T ...
Components and Components Location
Components
1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Passenger Airbag (PAB)5. Side Airbag (SAB)6. Curtain Airbag (CAB)7. Seat Belt Pretensioner (BPT)8. Front Impact Sensor (FIS)9. ...
Other Information:
Noise and smoke
When inflated, the air bags make a loud noise and leave smoke and powder in the
air inside the vehicle. This is normal and is a result of the ignition of the air
bag inflator. After the air bag in ...
Front Washer Motor Repair procedures
Inspection
Front Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with wa ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026