Kia Sedona: Fuel Tank Pressure Sensor (FTPS) Specifications - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Fuel Tank Pressure Sensor (FTPS) Specifications

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) Specifications

Specification
Item
Specification
Supply Voltage (V)
5
Operation Voltage (V)
4.75 ~ 5.25

Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Ref=5V]
-6.67 (-0.06, -0.97)
0.5
0
2.5
+6.67 (0.068, 0.97)
4.5

Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. AcceleratorPositionOut ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

Other Information:

Don
Under some conditions your parking brake can freeze in the engaged position. This is most likely to happen when there is an accumulation of snow or ice around or near the rear brakes or if the bra ...

IMS (Integrated Memory System) module Components and Components Location
Components Connector Pin Information No.Connecter AConnecter BConnecter CConnecter D1-Batt (+)--2Front tilt motor (Up)GND-Seat rear height sensor3Rear height motor (Up)Batt (+)Slide switch signa ...

Categories

Copyright © www.kisedona.com 2016-2026