Kia Sedona: Filler-Neck Assembly Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
| Removal |
| 1. |
Open the fuel filler door and then remove the filler-neck mounting bolts (A).
|
| 2. |
Left the vehice. |
| 3. |
Remove the rear-LH wheel, tire, and the inner wheel house (A).
|
| 4. |
Disconnect the fuel filler hose (A). |
| 5. |
Disconnect the ventilation hose quick-connector (B).
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pressure Regulator Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the fuel sender connector (A) and fuel pump connector (B).
3.
Remove the cushion pipe fixi ...
Delivery Pipe Repair procedures
Removal
When removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, injury may be caused by leakage of
high pressure fuel. For ...
Other Information:
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when :
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered with for ...
Rear Door Inside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
After loosening the mounting screws, remove the rear door inside handle (A).
3.
Disconnect the rear d ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026