Kia Sedona: Care of seat belts - Seat belts - Safety features of your vehicle - Kia Sedona YP Owners ManualKia Sedona: Care of seat belts

Third generation YP (2014-2020) / Kia Sedona YP Owners Manual / Safety features of your vehicle / Seat belts / Care of seat belts

Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse.

WARNING - Pinched seat belt

Make sure that the webbing and/or buckle does not get caught or pinched in the rear seat when returning the rear seatback to its upright position. A caught or pinched webbing/ buckle may become damaged and could fail during a collision or sudden stop.

Periodic inspection

All seat belts should be inspected periodically for wear or damage of any kind. Any damaged parts should be replaced as soon as possible.

Keep belts clean and dry

Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.

When to replace seat belts

The entire in-use seat belt assembly or assemblies should be replaced if the vehicle has been involved in an accident. This should be done even if no damage is visible. Additional questions concerning seat belt operation should be directed to an authorized Kia dealer.

Seat belt precautions
Infant or small child You should be aware of the specific requirements in your country. Child and/or infant seats must be properly placed and installed in the rear seat. For more information abou ...

Child restraint system
Children riding in the vehicle should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accid ...

Other Information:

Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery n ...

Specifications
Specification ItemSpecificationRated voltage3VOperating temperature-30°C ~ +60°C (-22°F ~ +140°F)RF ModulationFSKLF ModulationASKRF frequency433.92 MHzButton number4 or 6FunctionDoor lockDoor ...

Categories

Copyright © www.kisedona.com 2016-2020