Kia Sedona: Transaxle Oil Temperature Sensor Specifications - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Transaxle Oil Temperature Sensor Specifications

Third generation YP (2014-2020) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Specifications

Specification
Item
Specification
Type
*NTC thermistor
Temp.[(°C)°F] / Resistance (kΩ)
(-40)-40 / 48.1
(-20)-4.0 / 15.6
(0)32.0 / 5.88
(20)68.0 / 2.51
(40)104.0 / 1.19
(60)140.0 / 0.61
(80)176.0 / 0.32
(100)212.0 / 0.18
(120)248.0 / 0.10
(140)284.0 / 0.06
(150)302.0 / 0.05

*NTC: Negative Temperature Coefficient
Transaxle Control Module (TCM) Repair procedures
Inspection 1. TCM ground circuit test: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check point. Specification: Below 1Ω ...

Transaxle Oil Temperature Sensor Description and Operation
Description • The sensor used is a thermistor (NTC) in which resistance changes with temperature variation. • The TCM supplies about 5 voltage to the sensor; the output value ...

Other Information:

Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine is cool, drain the engine coolant fro ...

Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are cold. ...

Categories

Copyright © www.kisedona.com 2016-2020