If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure.
1.
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability.
2.
If the steering pulls to the opposite side, rotate the front and rear tires, and perform a road test again.
3.
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test.
4.
If the steering continues to pull to the opposite side, replace the front wheels with new ones.
Tire Wear
•
Using tires and wheels of other than the recommended sizes
could cause unusual handling characteristics and poor vehicle control,
resulting in a serious accident.
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.0630 in.)
2.
If the remaining tread depth (A) is less than the limit, replace the tire.
When the tread depth of the tires is less than 1.6 mm(0.0630 in), the wear indicators (B) will appear.
Electronic Stability Control (ESC) OFF Indicator Light
This indicator light illuminates :
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When you d ...
Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield c ...