Kia Sedona: Fuel Tank Pressure Sensor (FTPS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection

1.	Connect the GDS to the Data Link Connector (DLC).

Measure the output voltage of the FTPS.

Pressure [kPa (kgf/cm², psi)]	Output Voltage (V) [Ref=5V]
-6.67 (-0.06, -0.97)	0.5
0	2.5
+6.67 (0.068, 0.97)	4.5

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Remove the service cover (A).

3.	Disconnect the fuel tank pressure sensor connector (A).

4.	Remove the fuel tank pressure sensor (A) after releasing the hooks veritically.

Installation

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Insert the sensor in the installation hole and be careful not to damage sensor when installing.

1.	Install in the reverse order of removal.

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams

Circuit Diagram ...

Injector Specifications

Specification ItemSpecificationCoil Resistance (Ω)0.98 ~ 1.14 [20°C(68°F)] ...

Other Information:

Description and Operation
Description It''s a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment''s illumination condition. It activa ...

General Information
Warning And Caution Labels 1. Fan caution2. Radiator cap caution3. Battery caution Battery Caution Label Warning / Caution Label (Cont''d) A.Keep lighted cigarettes and all other flames or ...

Kia Sedona: Fuel Tank Pressure Sensor (FTPS) Repair procedures

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams

Injector Specifications

Other Information:

Categories