Kia Sedona: Injector Specifications

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Injector Specifications

Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection 1. Connect the GDS to the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]-6.67 (-0.06, -0.97)0.502 ...

Injector Description and Operation

Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

Other Information:

Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with an L wrench (A). Tightening torque : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) ...

Steering Angle Sensor Description and Operation
Description Installed in MDPS (Motor Driven Power Steering), the Steering Angle Sensor (SAS) sends signals to HECU through CAN communication line. The SAS is used to determine turning directio ...