Kia Sedona: Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Auto Lighting Control System / Description and Operation

Description

It''s a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment''s illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.

1.	Do not place other devices on top of this device.

2.	Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.

3.	Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may vary depending on the climate, season, and surrounding environment.

4.	Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.

5.	Error may occur if light block coating that may change interior illumination is applied.

Schematic Diagrams

Circuit Diagram ...

Auto Light Sensor Repair procedures

Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor''s input (illuminat ...

Other Information:

Rear Power Mosfet Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Operate the control switch to raise the voltage up to high ...

26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation
Description • 26 Brake control solenoid valve is a Variable Force Solenoid (VFS) type. • When TCM supplies variable current to solenoid valve, hydraulic pressure of 26 brake is ...

Kia Sedona: Description and Operation

Schematic Diagrams

Auto Light Sensor Repair procedures

Other Information:

Categories