Kia Sedona: Rail Pressure Sensor (RPS) Description and Operation
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS), installed on the delivery pipe,
measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Rail Pressure Sensor (RPS) Specifications
Specification
Pressure [MPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]0 (0, 0)0.510 (102, 1450)2.520 (204, 2900)4.5
...
Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram
...
Other Information:
Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia upper panel.
(Refer to Body - "Center Fascia Panel")
3.
Remove the start/stop button (A) after looseni ...
Fuel Gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
✽ NOTICE
The fuel tank capacity is given in chapter 8.
The fuel gauge is supplemented by a low fuel warn ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026