Kia Sedona: Heated Steering wheel Repair procedures - Steering wheel - Steering System - Kia Sedona YP Service ManualKia Sedona: Heated Steering wheel Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Steering System / Steering wheel / Heated Steering wheel Repair procedures

Inspection
1.
Measure the resistance of NTC and Heated pad.
NTC resistance : 3.42 ~ 4.18 kΩ (Standard : 25°C)
Heated pad resistance : 1.5 ~ 1.9 Ω (Standard : 19 ~ 21°C)
2.
Measure the temperature.
The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute.
The temperature of wheel surface grip must keep 38°C after 25 minutes.
Heated Steering wheel Schematic Diagrams
System Circuit Diagram ...

Restraint
...

Other Information:

Rear Wheel Speed Sensor Repair procedures
Removal 1. Remove the rear wheel speed sensor connector (A). 2. Remove the rear wheel speed sensor. (Refer to Driveshaft and Axle - "Rear Hub - Carrier") 3. Install in the reverse order o ...

Checking the coolant level
WARNING - Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in se ...

Categories

Copyright © www.kisedona.com 2016-2026