Kia Sedona: Crankshaft Position Sensor (CKPS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Crankshaft Position Sensor (CKPS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the battery tray.
(Refer to Engine Electrical System - "battery")
4.
Disconnect the crankshaft position sensor connector (A).
5.
Remove the mounting bolt (B), and then vertically remove the sensor from the transaxle housing.

Installation
   
•
Install the component to the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage sensor when installing.
1.
Install in the reverse order of removal.

Crankshaft position sensor installation bolt:
6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram ...

Crankshaft Position Sensor (CKPS) Troubleshooting
Wave Form ...

Other Information:

Specifications
Tightening Torque ItemN.mkgf.mlb-ftPassenger airbag(PAB)7.8 ~ 11.80.8 ~ 1.25.8 ~ 8.7Curtain airbag (CAB)Bolt7.8 ~ 10.80.8 ~ 1.25.8 ~ 8.7Nut3.9 ~ 5.90.4 ~ 0.62.9 ~ 4.3Seat Belt Anchor Bolt39.2 ~ 5 ...

Cylinder Head Cover Repair procedures
Removal [LH Cylinder Head Cover] 1. Remove the air duct. (Refer to Intake And Exhaust System - "Air Cleaner") 2. Remove the battery. (Refer to Engine Electrical System - "Battery") 3. ...

Categories

Copyright © www.kisedona.com 2016-2026