Kia Sedona: Barometric Pressure Sensor (BPS) Specifications - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Barometric Pressure Sensor (BPS) Specifications

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Specifications

Specification
Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Ref=5V]
10.0 (0.01, 0.15)
0.50
55.0 (0.56, 7.98)
2.21
115.0 (1.17, 16.9)
4.50

ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2 ...

Barometric Pressure Sensor (BPS) Description and Operation
Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assemby. It senses absolute pressure of the air cleaner assemby and transfers the ...

Other Information:

Relay Box (Engine Compartment) Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay block. Power Relay (Type A) Check for continuity between the terminals. ...

If the engine does not start
If engine doesn't turn over or turns over slowly 1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2.Check the ...

Categories

Copyright © www.kisedona.com 2016-2025