Kia Optima Manuals

Kia Sedona: Drive Belt Repair procedures - Power Train - Maintenance - Kia Sedona YP Service ManualKia Sedona: Drive Belt Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Maintenance / Power Train / Drive Belt Repair procedures

Inspection
1.
Check belt for maintenance and V-ripped part for abnormal wear. Replace if necessary.
   
•
Do not bend, twist or turn the drive belt inside out.
•
Do not allow the drive belt to come into contact with oil, water and steam.
2.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
   
Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Removal and Installation
1.
Remove the engine room under cover and engine room RH side cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
2.
To release the tension, turn the drive belt tensioner counterclockwise and then remove the drive belt (A).
[HPS]

[MDPS]

   
When installing the drive belt, follow the order below:
Crankshaft damper pulley → A/C compressor pulley → Idler Pulley → alternator pulley → water pump pulley → drive belt auto tensioner pulley.
Rotate the auto tensioner arm by turning the auto tensioner arm boss (A) counterclockwise using a wrench. After installing the drive belt to the auto tensioner pulley, slowly release the auto tensioner arm.

3.
Install in the reverse order of removal.
Cooling System Repair procedures
Inspection Radiator hoses 1. Check radiator hoses for the following (1) Improper attachment (2) Leaks (3) Cracks (4) Damage (5) Loose connections (6) Chafing (7) Deterio ...

Engine Oil and Filter Repair procedures
Inspection Engine Oil Level     Be sure that the vehicle is on level ground. 1. Warm up and stop the engine, and then wait for 5 minutes. 2. Turn the engine off an ...

Other Information:

High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on.To prevent the bat ...

Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. When all entrances ar ...

Categories

Copyright © www.kisedona.com 2016-2026