Kia Sedona: Heater & A/C Control Unit (Manual) Repair procedures| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the center fascia lower panel (A) after loosening the screw.
|
| 4. |
Disconnect the heater & A/C controller connectors (A).
|
| 5. |
Remove the heater & A/C controller (A) from center fascia lower panel (B) after loosening the screws.
|
| 6. |
Install in the reverse order of removal.
|
Heater & A/C Control Unit (Manual) Components and Components Location
Heater & A/C Control Unit (DATC) Components and Components LocationChecking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage ...