Kia Sedona: Rear In-car Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear In-car Sensor Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the rear in-car sensor (A).

2.	Disconnect the rear in-car sensor connector (A).

Install in the reverse order of removal.

Make sure that the connectors are plugged in properly.

Rear Power Mosfet Repair procedures

Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Operate the control switch to raise the voltage up to high ...

Controller

...

Other Information:

Brake Line Components and Components Location
Components ...

Components and Components Location
Component Location 1. Head lamp leveling actuator (Built-in Head lamp)2. Head lamp leveling unit (Rear right only) ...

Kia Sedona: Rear In-car Sensor Repair procedures

Rear Power Mosfet Repair procedures

Controller

Other Information:

Categories