Kia Sedona: Rear Power Mosfet Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear Power Mosfet Repair procedures

Inspection

1.	Turn the ignition switch ON.

2.	Manually operate the control switch and measure the voltage of the blower motor.

Operate the control switch to raise the voltage up to high speed.

Segment	Manual Blower Voltage (V)
1	3.8
2	4.6
3	5.9
4	7.2
5	8.3
6	9.5
7	11.3
8	Battery (+)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the luggage side trim [RH]. (Refer to Body - "Luggage Side Trim")

3.	Disconnect the power mosfet connector and then remove the power mosfet (A) after loosening the screws.

4.	Install in the reverse order of removal.

Rear Mode Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...

Rear In-car Sensor Repair procedures

Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

Parking Brake Assembly Repair procedures
Removal Parking Brake Shoe 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear tire and wheel. 3. Remove the rear brake caliper and Rear disc brake. (Refer ...

Specifications
Specifications AVN Head Unit ItemSpecificationPower supplyDC 14.4V Negative groundTuning typePLL SYNTHESIZED TUNINGLoad impedance2Ω x 4 (Front/Rear/Woofer)4Ω x 2 (Tweeter)Antenna80PF 75ΩDa ...

Kia Sedona: Rear Power Mosfet Repair procedures

Rear Mode Control Actuator Repair procedures

Rear In-car Sensor Repair procedures

Other Information:

Categories