Kia Sedona: Line Pressure Control Solenoid Vale Specifications - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Line Pressure Control Solenoid Vale Specifications

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Specifications

Specification
Item
Specification
Control type
N/H (Normal High)
Control pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)
Current value (mA)
50 ~ 850
Coil resistance(Ω)
5.1 ± 0.3

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Me ...

Line Pressure Control Solenoid Vale Components and Components Location
Component Location 1. Line pressure control solenoid valve (LINE_VFS) ...

Other Information:

Rear Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the fil ...

Injector Drive Box (IDB) Repair procedures
Removal 1. Turn the ignition switch off and disconnect the battery negative (-) Terminal. 2. Remove the mounting nuts (A) and disconnect the connector (B), and then remove the injector drive b ...

Categories

Copyright © www.kisedona.com 2016-2026