Kia Sedona: Cluster Ionizer (DATC only) Description and Operation - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Cluster Ionizer (DATC only) Description and Operation

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Cluster Ionizer (DATC only) Description and Operation

Description
The cluster ionizer disinfects and decomposes bad smell from the air conditioner or air inflow. Also, it cleans the inside air of a vehicle.
When the ignition switch is ON, the ionizer runs "CLEAN" mode and then "ION" mode, switching between both modes.
In the “CLEAN” mode, the cluster ionizer generates negative ions and positive ions to help clean smells from the air.
In the “ION” mode, the cluster ionizer generates negative ions and cleans inside air of a vehicle.
Auto Defogging Sensor (DATC only) Repair procedures
Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the auto defogging se ...

Cluster Ionizer (DATC only) Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal50Cluster ion generator fault * For diagnostic procedur ...

Other Information:

RCTA (Rear Cross Traffic Alert)
When your vehicle moves backwards from a parking position, the sensor detects approaching vehicles to the left or right side direction and gives information to the driver. ...

Anti-Pinch Strip Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the tail gate trim. (Refer to Body - "Tail Gate Trim") 3. Disconnect the anti-pinch strip sensor connector (A). 4. R ...

Categories


Copyright © www.kisedona.com 2016-2024