Kia Sedona: Cluster Ionizer (DATC only) Repair procedures
Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Cluster Ionizer (DATC only) Repair procedures
| Inspection |
| 1. |
Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
| 3. |
Disconnect the cluster ionizer connector (A). |
| 4. |
Remove the cluster ionizer (B) after loosening the screw.
|
| 5. |
Install in the reverse order of removal. |
Cluster Ionizer (DATC only) Description and Operation
Description
The cluster ionizer disinfects and decomposes bad smell from
the air conditioner or air inflow. Also, it cleans the inside air of a
vehicle.
When the ignition switch is ON, the ion ...
Heater
...
Other Information:
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine will probably be too hot. If this happens,
you should:
1.Pull off the ...
Battery Sensor Repair procedures
Removal
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative (-) terminal (A).
Battery negative (-) terminal tightening nut :
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2025 Owners Manual
- Kia Sedona YP 2014-2025 Service Manual
Copyright © www.kisedona.com 2016-2025