Kia Sedona: Auto Defogging Sensor (DATC only) Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Auto Defogging Sensor (DATC only) Repair procedures
| Inspection |
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the auto defogging sensor cover (A).
|
| 3. |
Remove the auto defogging sensor (A) after disconnecting the auto defogging sensor connector (B).
|
| 4. |
Install in the reverse order of removal. |
Auto Defogging Sensor (DATC only) Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal to blow out wind for defogging
if moisture occurs. On receiving the signal from ...
Cluster Ionizer (DATC only) Description and Operation
Description
The cluster ionizer disinfects and decomposes bad smell from
the air conditioner or air inflow. Also, it cleans the inside air of a
vehicle.
When the ignition switch is ON, the ion ...
Other Information:
Crankshaft Damper Pulley Repair procedures
Removal and Installation
1.
Remove the engine room under cover and engine room RH side cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
2.
Remove the RH side front ...
Troubleshooting
Engine Overheat Troubleshooting
Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026