Use the GDS to check input/output values in the Power Sliding
Door control module for each position. If there''s any malfunctioning,
replace the anti-pinch strip.
2.
To check the operation of the anti-pinch strip, choose “Power Sliding/Tailgate” and vehicle on the menu.
3.
Select "Power Sliding Door".
4.
After selecting sensor output value, operate the Power
Sliding Door in power mode and check for output value of anti-pinch
strip sensor.
5.
Replace the anti-pinch strip sensor if there’s no change in output value in OFF to ON mode.
Removal
1.
Disconnect the negative battery terminal.
2.
Disconnect the captive clip and remove the Anti-pinch strip(A)
Inspection
Overhead Console Door Switch Inspection
1.
When inspecting, use the inspection equipment to check for
input/output values of Overhead console door switch. If there''s any
malfunct ...
Front Door Belt Inside Weatherstrip Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).
3.
Install in the reverse order of removal.
...
Smart cruise control system (SCC)
➀ Cruise indicator
➁ SET indicator
➂ Set speed
➃ Vehicle-to-vehicle distance
The SCC allows you to program the vehicle to maintain a set speed so long as
it is no ...