Kia Sedona: Components and Components Location - Keyless Entry And Burglar Alarm - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Components and Components Location

Component Location

1. Hood switch
2. Burglar horn
3. BCM & RF receiver
4. Key warning switch
5. Front door lock actuator & switch
6. Rear door lock actuator & switch
7. Tail gate actuator & switch (Power tail gate module)

Specifications
Specification ItemSpecificationRated voltage3VOperating temperature-30°C ~ +60°C (-22°F ~ +140°F)RF ModulationFSKLF ModulationASKRF frequency433.92 MHzButton number4 or 6FunctionDoor lockDoor ...

Description and Operation
Description Burglar Alarm State [B/A State] B/A StateDescriptionDISARM 1) In "DISARM" state, vehicle start inhibition is disabled. So, when door, hood, or tailgate is opened, there is no ala ...

Other Information:

Non-operational conditions of parking assist system
Parking assist system may not operate normally when : 1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.) 2. Sensor is covered with foreign matter, such as snow or ...

Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative ...

Categories

Copyright © www.kisedona.com 2016-2026