Kia Sedona: Front Door Belt Inside Weatherstrip Repair procedures - Front Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Door Belt Inside Weatherstrip Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Inside Weatherstrip Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Front Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down front door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside weatherstrip (A). 3. ...

Front Door Side Weatherstrip Repair procedures
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, and then remove the front doo ...

Other Information:

Seat Heater Schematic Diagrams
Circuit Diagram Connector Pin Information No.DescriptionNo.Description1Power Seat Batt (+)18Left NTC (+)2Left air ventilation/heater cushion batt (+)19Air ventilation/heater ECU batt (+)3Left ai ...

Front Driveshaft Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to dam ...

Categories

Copyright © www.kisedona.com 2016-2026