Kia Sedona: Fuel Tank Air Filter Repair procedures - Evaporative Emission Control System - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Fuel Tank Air Filter Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the canister close valve (C).

6.
Remove th fuel tank air filter (B) after loosening the mounting bolts (A).

Fuel tank air filter mounting bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Installation
1.
Install in the reverse order of removal.
Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

Exhaust Emission Control System
...

Other Information:

Schematic Diagrams
Circuit Diagram Connector Pin Information No.Motor ConnectorSunroof Wiring Connector1Battery 1GND 12Open alarmRear lock switch3GND 1IGN4Rear lock switchSignal C5-Signal A6Signal CBattery 17Signa ...

Blower Unit Components and Components Location
Components Location 1. Blower Unit Components 1. Inlet Seal2. Intake Actuator3. Antinoise Pad4. Blower Upper Case5. Blower Lower Case6. Blower Motor7. Inlet Duct Upper Case8. Inlet Door As ...

Categories

Copyright © www.kisedona.com 2016-2026