Kia Optima Manuals

Kia Sedona: Front Door Window Glass Repair procedures - Front Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Door Window Glass Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).

3.
Remove the front door window glass mounting hole plug (A).

4.
Before removing the front door glass (C), loosen the mounting bolt (A) as loosely as possible and loosen the mounting bolt (B) completely.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

   
Be careful not to drop the glass and/or scratch the glass surface.
   
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
5.
Carefully adjust the front door window glass (A) until the bolts are visible, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
   
When removing the front door glass, be careful not to separate the glass mounting bracket (B).

6.
Install in the reverse order of removal.
   
•
Roll the glass up and down to see if it moves freely without binding.
•
Adjust glass position as needed.
•
Make sure that the door locks and opens properly.
•
Replace any damaged clips.
Front Door Window Glass Components and Components Location
Component Location 1. Front door window glass ...

Front Door Module Components and Components Location
Component Location 1. Front door module ...

Other Information:

Repair procedures
Removal [Horn (Low pitch)] 1. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the mounting clip (A). 3. Remove the low pitch ...

Purge Control Solenoid Valve (PCSV) Description and Operation
Description Purge Control Solenoid Valve (PCSV), installed on the surge tank, controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM ...

Categories

Copyright © www.kisedona.com 2016-2026