Kia Sedona: Shift Cable Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Repair procedures

Removal

1.	Move the shift lever to "N" range.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner)

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

Loosen the nut (A) and then remove the shift cable (B) from the bracket (c).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.	Remove the knob (A) and boots (B) by pulling them in the direction of the arrow after separating the boots from the console upper cover.

6.	Remove the floor console assembly. (Refer to Body - "Console")

7.	Remove the shift cable (A) from the shift lever.

Remove the cable retainer (A) by loosening the nuts (B)

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

9.	Remove the shift cable by pulling it inward.

Installation

Install in the reverse order of removal.

•	Check that the shift lever and manual control lever are placed in the "N" position.

•	Insert the shift cable after checking the direction of projection (A) to prevent wrong assembly.

Shift Cable Components and Components Location

Components 1. Shift lever assembly2. Shift cable assembly3. Shift cable retainer ...

Hydraulic System

...

Other Information:

Luggage Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the luggage room lamp lens (A) from the luggage room lamp with a flat-tip screwdriver. 3. Remove the luggage room lamp (A ...

Rear Alignment Repair procedures
Rear wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on ...

Kia Sedona: Shift Cable Repair procedures

Shift Cable Components and Components Location

Hydraulic System

Other Information:

Categories