Kia Sedona: Line Pressure Control Solenoid Vale Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure the resistance between power terminal (5) and signal terminal (17).
|
| Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
| 1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Line Pressure Control Solenoid Vale Schematic Diagrams
Circuit Diagram
...
SS-A Solenoid Valve(ON/OFF) Specifications
Specification
ItemSpecificationControl type ON/OFFCurrent value (mA)5.0 Coil resistance(Ω)10 ~ 11
...
Other Information:
Seat Belt Buckle Switch (BS) Components and Components Location
Components
...
Brake Line Repair procedures
Removal
1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
&nb ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026