Type A
Type B
The front passenger's seat belt warning light will activate to the following table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the vehicle speed decreases below 5 km/h (3 mph). If the vehicle speed increases above 5 km/h (3 mph), the warning light will blink again.
Riding in an improper position adversely affects the front passenger's seat belt warning system. It is important for the driver to instruct the passenger as to the proper seating instructions as contained in this manual.
Description and Operation
Description
Power Sliding Door is a system which can open/close the door
automatically by using a switch located on overhead console and rear
seat trim, internal/outer handle of a sliding door ...
Input Speed Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
M ...