Replacement |
Be careful not to damage the fender and body. |
When removing the clips, use a clip remover. |
1. |
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover") |
2. |
Remove the head lamps.
(Refer to Body Electrical System - "Head Lamps") |
3. |
Remove the delta fixed glass.
(Refer to "Delta Fixed Glass") |
4. |
Rmove the cowl top side cover (A). |
5. |
Remove the fender side cover (A). |
6. |
Loosen the wheel nut (A) and remove the wheel (B). |
7. |
Remove the front mud guard.
(Refer to "Front Mud Guard") |
8. |
Loosen the front wheel guard mounting clips and screws. |
9. |
Loosen the screw and remove the front bumper bracket (A). |
10. |
Loosen the bolts & nut and remove the fender (A). |
11. |
Install in the reverse order of removal.
|
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Removal
1.
Turn the ignition switch OFF and d ...
Rear temperature control
From front seat
Set the rear climate control selection (REAR ON) button to the ON position and
press the rear fan speed control button in the front climate control panel to the
desired position ...