Kia Sedona: Refrigerant Line Repair procedures - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Refrigerant Line Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Refrigerant Line Repair procedures

Replacement
1.
Discharge refrigerant from the refrigeration system.
2.
Replace faulty tube or hose.
   
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten the bolt or nut joint to the specified torque.
   
Connections should not be tightened to exceed the specified torque.
4.
Evacuate air in the refrigeration system and charge system with refrigerant.

Specified amount
1100 ± 25g (38.8 ± 0.88oz.)

5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for refrigerant leakage.
6.
Inspect A/C operation.
Compressor oil Repair procedures
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (P ...

Compressor Description and Operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low tempera ...

Other Information:

Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery n ...

Alternator Repair procedures
Removal 1. Disconnect the battery negative (-) terminal. 2. Remove the cooling fan. (Refer to Engine Mechanical System - "Cooling Fan") 3. Lift the vehicle. 4. Remove the engine room ...

Categories

Copyright © www.kisedona.com 2016-2026