Kia Sedona: Compressor Description and Operation - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Compressor Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor Description and Operation

Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Variable Swash Plate Compressor
The compressor has a swash plate that rotates to reciprocate pistons, which compress refrigerant.
The variable swash plate compressor controls the swash plate angle to change the refrigerant displacement. It achieves precise cooling capability control in accordance with vehicle interior and driving conditions.
The internally controlled variable swash plate compressor changes the swash plate angle by a MCV (Mechanical Control Valve) in accordance with fluctuation of a suction pressure.
The externally controlled variable swash plate compressor changes the swash plate angle by an ECV (Electric Control Valve) in accordance with an electrical signal from the heater & A/C control unit.
This enables stable temperature control and improved driving sensation.
ECV Control Diagram

Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from the refrigeration system. 2. Replace faulty tube or hose.     Cap the open fittings immediately to keep moisture or dirt out ...

Compressor Components and Components Location
Components 1. Clutch Bolt2. Limiter Bolt3. Limiter & Hub Assembly4. Snap Ring5. Pulley6. Compressor Assembly ...

Other Information:

Power sliding door operation
Push the corresponding main control button on the overhead console to open or close the power sliding door. However, the power sliding door will not open with the main control button when ...

Manual climate control system
1. Turn the ignition switch to the ON position. 2. Turn the fan speed control knob to the OFF (0) position. 3. Turn the mode selection knob to the defrost position (). 4. Push the air intake cont ...

Categories

Copyright © www.kisedona.com 2016-2026