Kia Sedona: Alternator Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Electrical System / Charging System / Alternator Repair procedures

Removal

1.	Disconnect the battery negative (-) terminal.

2.	Remove the cooling fan. (Refer to Engine Mechanical System - "Cooling Fan")

3.	Lift the vehicle.

4.	Remove the engine room RH side cover. (Refer to Engine Mechanical System - Engine Room Under Cover - Repair procedures - "Engine Room Side Cover")

5.	To release the auto tension pully (A), turn the drive belt tensioner counterclockwise.

6.	Remove the drive belt (A).

7.	Disconnect the alternator connector (A).

Disconnect the alternator cable (A) from the ''B'' terminal.

Alternator "B" terminal mounting nut:

9.8 ~ 11.8 Nm (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Remove the alternator (B) after loosening the mounting bolts (A).

Alternator mounting bolt:

49.0 ~ 63.7 Nm (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 Ib-ft)

Installation

1.	Install in the reverse order of removal.

2.	Install the drive belt. (Refer to Engine Mechanical System - "Drive Belt")

Alternator Schematic Diagrams

Circuit Diagram • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal (High volta ...

Battery Specifications

Specification ItemSpecificationModel typeCMF80L-BCICapacity [20HR/5HR] (AH)80/64 Cold Cranking Amperage (A)660 (SAE) / 528 (EN)Reserve Capacity (Min)145 • ...

Other Information:

Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia upper panel. (Refer to Body - "Center Fascia Panel") 3. Remove the start/stop button (A) after looseni ...

Crash Pad Lower Panel Repair procedures
Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Kia Sedona: Alternator Repair procedures

Alternator Schematic Diagrams

Battery Specifications

Other Information:

Categories