Kia Sedona: Rear Temperature Control Actuator Description and Operation - Rear Heater - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Rear Temperature Control Actuator Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear Temperature Control Actuator Description and Operation

Description
The heater unit consists of mode control actuator and temperature control actuator.
Located in the heater unit, the temperature control actuator regulates the temperature in the following procedure.
Signal from control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.
Rear Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...

Rear Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the actuator operates to the recirculation position when 12V is connect ...

Other Information:

Components and Components Location
Component Location (1) 1. Smart key unit (SMK)2. Interior antenna 23. Interior antenna 14. Buzzer5. Door outside handle Component Location (2) 1. Bumper antenna2. Tail gate open switch3. In ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Me ...

Categories

Copyright © www.kisedona.com 2016-2026