Kia Sedona: Rear Blower Motor Repair procedures - Rear Heater - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Rear Blower Motor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear Blower Motor Repair procedures

Inspection
1.
Connect the battery voltage and check the blower motor rotation.

2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
3.
Replace the blower motor if it is proved that there is a problem with it.
Replacement
1.
Disconnect the battery negative terminal.
2.
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim")
3.
Remove the rear heater duct (A) after loosening the bolts.

4.
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

5.
Install in the reverse order of removal.
Rear Evaporator Core Repair procedures
Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Remove the rear heater & A/C lower case after loosening the screws. 3. Remove the ...

Rear Temperature Control Actuator Description and Operation
Description The heater unit consists of mode control actuator and temperature control actuator. Located in the heater unit, the temperature control actuator regulates the temperature in the follow ...

Other Information:

Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Me ...

Categories

Copyright © www.kisedona.com 2016-2026