Kia Optima Manuals

Kia Sedona: Rear Spoiler Repair procedures - Body Side Moulding - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Spoiler Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Body Side Moulding / Rear Spoiler Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).

3.
Remove the rear spoiler plug hole cap (A) and then loosen the nuts (B).
Tightening torque :
5.9 ~ 6.4N.m (0.6 ~ 0.65kgf.m, 4.3 ~ 4.7lb-ft)

4.
Remove the rear spoiler (A).

5.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
Roof Side Moulding Repair procedures
Replacement [General Type]     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with pro ...

Front Wheel Guard Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

Auto light position
When the light switch is in the AUTO light position, the taillights and headlights will turn ON or OFF automatically depending on the amount of light outside the vehicle. Never place anything ...

Repair procedures
Removal [Horn (Low pitch)] 1. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the mounting clip (A). 3. Remove the low pitch ...

Categories

Copyright © www.kisedona.com 2016-2026