Kia Sedona: Overhead Console Lamp Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the overhead console lamp (A) after loosening the screws.

3.	Disconnect the connector (A) from the overhead console lamp.

Bulb Replacement

1.	Detach the overhead console lamp lens (A) from the overhead console lamp with a flat-tip screwdriver.

2.	Disconnect the overhead console lamp bulb (A).

Installation

1.	Connect the overhead console lamp connector.

2.	Install the overhead console lamp.

3.	Connect the negative (-) battery terminal.

Inspection

1.	Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Personal Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the personal lamp (A) using a flat-tip screwdriver. 3. Disconnect the personal lamp connector (A). Installation 1. C ...

Hazard Lamp Switch Repair procedures

Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. Connector Pin Information No.DescriptionNo.Description1ILL+ (TAIL)2 ...

Other Information:

Components and Components Location
Components 1. Windshield glass 2. Windshield glass moulding ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Kia Sedona: Overhead Console Lamp Repair procedures

Personal Lamp Repair procedures

Hazard Lamp Switch Repair procedures

Other Information:

Categories