Kia Sedona: Knock Sensor (KS) Schematic Diagrams

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Schematic Diagrams

Knock Sensor (KS) Description and Operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise that can cause engine damage. Two Knock Sensors (KS) are installed inside the V-valley of the cylinder bloc ...

Knock Sensor (KS) Repair procedures

Removal [Bank 1] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") ...

Other Information:

Seat belt restraint system
For maximum restraint system protection, the seat belts must always be used whenever the vehicle is moving. A properly positioned shoulder belt should be positioned midway over your shoulder ...

BJ Boot Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...