Kia Sedona: Hood Latch Release Handle Components and Components Location - Hood - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Hood Latch Release Handle Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Components and Components Location

Component Location

1. Hood latch release handle


Hood Weatherstrip Repair procedures
Replacement 1. Remove the glue on both ends (A) of the hood weatherstrip (B).     • Be careful not to scratch the hood weatherstrip. 2. Install in the r ...

Hood Latch Release Handle Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off ...

Other Information:

Rear mode selection
Front climate control is MAX A/C, : Rear air blows from the upper vents on the rear ceiling. Front climate control is : Rear air blows from the upper vents on the rear ceiling and the l ...

Charging System Warning Light
This warning light illuminates : Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction wit ...

Categories

Copyright © www.kisedona.com 2016-2026