Kia Optima Manuals

Kia Sedona: BJ Boot Repair procedures - Driveshaft Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: BJ Boot Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the Dynamic damper.
(Refer to Driveshaft Assembly - “Dynamic Damper”)
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
   
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
7.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
BJ Boot Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Front Axle Assembly
...

Other Information:

Components and Components Location
Components 1. Automatic transaxle assembly2. Inhibitor switch3. Transaxle Control Module (TCM)4. Valve body cover5. Solenoid valve harness6. Valve body assembly7. Line pressure control solenoid v ...

Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from the refrigeration system. 2. Replace faulty tube or hose.     Cap the open fittings immediately to keep moisture or dirt out ...

Categories

Copyright © www.kisedona.com 2016-2026